Phono Encoding; Cassette Operation - boytone BT-19DJB Operating Instructions Manual

Phono encoding

1. Set the function button to PHONO mode and then insert a memory device (USB drive,
SD or MMC card).
2. Put your record onto the turntable and get it ready for playback.
3. Press the record
memory device, then the USB or SD icon will be flashing on the LC display.
4. Press the skip up
or SD) for encoding, then press the record
(You can skip this step if only a USB drive or an SD/MMC card is inserted.)
5. The system will start the encoding mode after a few seconds.
6. Lower the tone arm to start playback of the record. During encoding, the USB or SD
icon will be flashing on the display.
7. To finish encoding, press the stop
PHONO mode.
NOTE:
 The recording speed is 1:1. Recording will take as long as playing the record.

The recording format is preset at MP3 bit rate 128 kbps.

Cassette Operation

1. Turn the volume knob clockwise to turn the equipment on.
2. Use the function selector to select TAPE/AUX mode.
3. Insert a cassette with the tape facing away from you, as illustrated on the right. The
EJECT/FAST FORWARD button will pop out and
the system will start playing the tape automatically.
4. Turn the volume knob to your desired level.
5. To fast forward the cassette tape, press the EJECT/FAST FORWARD button halfway
down while the cassette is playing. The tape will be advanced forward rapidly.
6. To resume normal playback, slightly press the EJECT/FAST FORWARD button again.
The button will fully pop out again.
REC button. It will take about 3 - 4 seconds to read the
or skip down button to select the desired mode (USB
REC button again to confirm.
button. The display will show "END" and return to
8