Table of Contents
Advertisement
Listening to the CD Player
Radio tuning
1. Turn the volume knob in a clockwise direction to turn the equipment on.
2. Use the function selector to select CD mode.
3. Press the Open CD tray button.
4. Unit will auto load and read the number of tracks.
5. Press the Play button to play selected CD track. Press next or previous buttons to play respective track.
(Note: Encoding from CD will not work with BT-21DJM-SP)
NOTE: Should your record stop before the last track finishes, set the auto stop control to OFF.
Your record will now play to the end, but you will have to stop the turntable rotation manually.
(Return the tone arm to its rest manually and if the turntable is still rotating, switch off the unit by
the volume control knob. Then set the auto stop control back to ON.)
Phono encoding
1. Set the function button to PHONO mode and then insert a memory device (USB drive, SD or MMC
card).
2. Put your record onto the turntable and get it ready for playback.
3. Press the record REC button. It will take about 3 - 4 seconds to read the memory device, then the USB
or SD icon will be flashing on the LC display.
4. Press the skip up or skip down button to select the desired mode (USB or SD) for encoding, then press
the record REC button again to confirm.(You can skip this step if only a USB drive or an SD/MMC card
is inserted.)
5. The system will start the encoding mode after a few seconds.
6. Lower the tone arm to start playback of the record. During encoding, the USB or SD icon will be flashing
on the display.
7. To finish encoding, press the stop button. The display will show "END" and return to PHONO mode.
Advertisement
Table of Contents
