Phono Encoding - boytone BT28SPB Operating Instructions Manual

5. Place the record on the turntable (use the 45 rpm adaptor, if required).
6. Move the lift lever towards the back to raise the tone arm from the arm park, then
slowly move the arm to the record, as illustrated on the right. The turntable will start
rotating.
7. Move the lift lever towards the front, the tone arm will gently drop onto the record
and playback will start.
8. To stop playback, move the lift lever towards the back to raise the tone arm. The
turntable will still be rotating but the record will stop playing. To continue playback,
move the lift lever towards the front.
9. To play a different piece on the record, move the lift lever towards the back, move the
raised tone arm to the start of the piece and then move the lift lever towards the front to
lower the tone arm and start playback.
10. To adjust the volume level, turn the volume knob to the right or left.
11. At the end of the record, move the lift lever towards the back to raise the tone arm and
move it back to the tone arm park, and then move the lift lever towards the front to lower
the arm onto its rest.
12. Alternatively, lift the tone arm off the record and return it to the arm rest manually.
When you have finished playing records, engage the tone arm lock to protect it from
13.
accidental movement. Turn the volume knob in a counterclockwise direction to switch
the unit off. Unplug it from the power supply if you are not going to use it for a while.
NOTE: Should your record stop before the last track finishes, set the auto stop control to
OFF. Your record will now play to the end, but you will have to stop the turntable
rotation manually. (Return the tone arm to its rest manually and if the turntable is
still rotating, switch off the unit by the volume control knob. Then set the auto stop
control back to ON.)

Phono encoding

1. Set the function button to PHONO mode and then insert a memory device (USB drive,
SD or MMC card).
2. Put your record onto the turntable and get it ready for playback.
3. Press the record REC button. It will take about 3 - 4 seconds to read the
memory device, then the USB or SD icon will be flashing on the LC display.
4. Press the skip up
or SD) for encoding, then press the record
or skip down button to select the desired mode (USB
REC button again to confirm.