Listening To Radio; Operating Instructions - boytone BT-19DJB Operating Instructions Manual

OPERATING INSTRUCTIONS

Listening to radio

Turn the volume knob in a clockwise direction to turn the equipment on.
1.
Use the function selector to select TUNER mode.
2.
Use the radio band selector to select the desired band (AM, FM or FM-Stereo).
3.
Turn and hold the tuning knob for a few seconds to tune into a radio station. The
4.
unit will start searching automatically and stop when a radio station is found.
Release the knob once a station has been found.
Repeat the above step until your desired radio station is found.
5.
Adjust the volume knob to your desired volume level.
6.
AM reception: the receiver has a built-in AM bar antenna. If reception is weak,
7.
slightly rotate or reposition the unit to improve AM reception. Rotate radio button
quickly for 3 channels to move into the mode of automatic selection.
FM reception: the receiver has a built-in FM wire antenna hanging at the rear
8.
cabinet. For best reception, completely unravel and extend this wire. Rotate
radio button quickly for 3 channels to move into the mode of automatic
selection.
FM and FM-stereo mode
 FM mode: use the radio band selector to select the FM band. Programs are received in
mono mode. Use this mode when stereo reception is weak.
 FM-Stereo mode: use the radio band selector to select FM-ST for receiving stereo
programs. Once a stereo signal is received, the ST icon will light up on the display.
AM/FM Radio memorization for preselected channel
1.Turn the volume knob clockwise to turn the equipment on.
2.Use the function selector to select TUNER mode.
3.Use the radio band selector to select the desired band (AM, FM or FM-Stereo)
4.Turn and hold the tuning knob for a few seconds to choose a desired radio station need to
save. Then press PROG button twice to set the Saved Number (such as P01,P02),AM
radio can be saved 10 channels, FM radio can be saved 30 channels.
5. Repeat the 4th operation to save other preselect radio stations
6