Phono Encoding - boytone BT-27G-C Instruction Manual

13. When you have finished playing records, engage the tone arm lock to protect it from
accidental movement. Turn the volume knob in a counterclockwise direction to switch the
unit off.
Unplug it from the power supply if you are not going to use it for a while.
NOTE: Should your record stop before the last track finishes, set the auto stop control to OFF.
Your record will now play to the end, but you will have to stop the turntable rotation manually.
(Return the tone arm to its rest manually and if the turntable is still rotating, switch off the unit
by the volume control knob. Then set the auto stop control back to ON.)

Phono encoding

1. Set the function button to PHONO mode and then insert a memory device (USB drive, SD or
MMC card).
2. Put your record onto the turntable and get it ready for playback.
3. Press the record REC button. It will take about 3 - 4 seconds to read the memory device, then
the USB or SD icon will be flashing on the LC display.
4. Press the skip up or skip down button to select the desired mode (USB or SD) for encoding,
then press the record REC button again to confirm.(You can skip this step if only a USB drive
or an SD/MMC card is inserted.)
5. The system will start the encoding mode after a few seconds.
6. Lower the tone arm to start playback of the record. During encoding, the USB or SD icon will
be flashing on the display.
7. To finish encoding, press the stop button. The display will show "END" and return to PHONO
mode.
NOTE:
• The recording speed is 1:1. Recording will take as long as playing the record.
• The recording format is preset at MP3 bit rate 128 kbps.