Aux In Encoding; Troubleshooting Guide - boytone BT-19DJB Operating Instructions Manual

device takes priority over cassette playback.
NOTE:
If you won't use the unit for a long time ,you had better take the CD out from the disk tray
door .

AUX IN encoding

1. Use the function selector to select TAPE/AUX mode and then insert a memory device
(USB drive, SD or MMC card).
2. Press the record
then the USB or SD icon will be flashing on the LC display.
3. Press the skip up
or SD) for encoding, then press the record
(You can skip this step if only a USB drive or an SD/MMC card is inserted.)
4. The system will start the encoding mode after a few seconds. During encoding, the
USB or SD icon will be flashing on the display.
5. To finish encoding, press the stop
to TAPE/AUX mode.
NOTE:
 The recording speed is 1:1. Recording will take as long as playing the CD (or other
auxiliary input).
 The recording format is preset at MP3 bit rate 128 kbps.

Troubleshooting Guide

If you are experiencing problems with your USB Turntable with Cassette Deck and Radio,
check in the section below whether there are any quick and easy checks you can do that
may help you solve the problem. If you cannot solve the problem by yourself, contact our
after sales support line for advice. Do not attempt to open, repair or modify the equipment
yourself.
REC button, it will take 3 - 4 seconds to read the memory device,
or skip down button to select the desired mode (USB
REC button again to confirm.
button. The display will show "END" and return
15