Appendix A Signal Connection Arrangements - ZyXEL Communications UAG50 User Manual

UAG50 User's Guide

Appendix A Signal Connection Arrangements

RJ-45 Ethernet Port
The UAG50 RJ-45 Ethernet port can connect to any networking devices that use a
standard LAN interface, such as a Hub/Switch Hub or Router. Use unshielded
twisted-pair (UTP) or shield twisted-pair (STP) cable to connect the networking
device to the RJ-45 Ethernet port.
Depending on the type of connection, 10Mbps or 100Mbps, use the following
Ethernet cable, as prescribed.
10Mbps: Use EIA/TIA-568-100-Category 3, 4 or 5 cables. 100Mbps: Use
EIA/TIA-568-100-Category 5 cable.
Figure RJ-45 Connector and Cable Pins
Note: To prevent loss of signal, make sure that the length of any twisted-pair
connection does not exceed 100 meters.
113