UAG50 User's Guide
Off: A port has not established any network connection.
Yellow light: A port has established a valid 10/100 Mbps network
connection.
Yellow Blinking: 10/100 Mbps traffic is traversing the port.
Reset Button: The UAG50 has a reset button at the rear panel of the device.
Use this function to reset the system back to factory defaults.
Power Jack: Used to connect the external power supply with the UAG50.
1-4-1 Printing a test page
After you have installed your printer, you should print a test page to make sure the
printer is functioning properly. To do this act as follows:
1. Turn the printer off.
2. Hold down the button A for approximately five seconds, and then turn the
printer on.
3. The printer will print a test page.
1-4-2 How to load paper rolls
Please follow the steps to correctly load paper rolls.
1
2
10