Hardware Installation; Wall Mount - Ubiquiti UAP-PRO UNIFI Quick Start Manual

Hardware Installation

The UniFi AP-PRO can be mounted to the wall or ceiling.
Perform the steps for the appropriate installation:

Wall Mount

1. Position the Mounting Bracket at the desired location on
the wall with the cable feed slot pointed towards the floor.
2. Use a pencil to mark the three holes on the wall. Use a
6 mm (¼") drill bit to drill the holes.
3. Follow the instruction for your Ethernet cable feed:
- Feeds Through the Wall
approximately 25 mm (1 in) in diameter, just below
the bottom center of the Mounting Bracket (as shown
above). Then feed the CAT5/6 cable through the hole.
- Feeds Along the Mounting Surface
Cable Feed Plug on the side of the UniFi AP-PRO.
Top
Optional 25 mm (1 in) Hole for
Ethernet Cable Feed through Wall
*640-00042-03*
640-00042-03
Cut or drill a circle
Remove the