Hardware Installation; Chapter 2: Installation - Ubiquiti UniFi UAP User Manual

UniFi AP/AP-LR User Guide

Chapter 2: Installation

Hardware Installation

The UniFi Enterprise WiFi System is powered by the
included PoE (Power over Ethernet) adapter. To install the
AP, perform the following steps:
1. Connect an Ethernet cable to the Ethernet port on the
UniFi Enterprise WiFi System.
2. Connect the power cord to the power port on the PoE
Adapter. Connect the other end to of the power cord to
a power outlet.
3. Connect the other end of the Ethernet cable to the
Ethernet port labeled PoE on the PoE Adapter.
Note: If you plan to mount the AP on your ceiling,
perform the ceiling mount installation steps
before connecting the Ethernet cable to the PoE
Adapter.
Ubiquiti Networks, Inc.
Below is an overview of the Power over Ethernet
connections.
Power Connection Diagram
Mounting the Access Point
The UniFi Enterprise WiFi System can be wall-mounted
or mounted on a ceiling. Perform the steps for the
appropriate installation:
Wall-Mount
1. Align the Wall-Mount Bracket with the Wall Mount text
facing up. There are horizontal and vertical lines on the
bracket to help with orientation.
2. Use a pencil to mark the holes on the wall.
3. Use a 6 mm drill bit to drill the holes in the wall.
4. Insert the 3 M3x20 Screw Anchors into the wall.
5. Secure the Wall-Mount Bracket to the wall by inserting
the M2.9x20 Self Tapping Screws into the anchors.
Chapter 2: Installation
Wall Mount text
3