Table of Contents
Advertisement
INST ALLING SYSTEM CABLE
1. Plug system cable into back of printer, and tighten two retaining
screws by turning them clockwise.
2. Install other end of cable as described in your system installation man-
ual.
~
RETAINING
SCREW
MA-10,015
3. Installation is now complete. Please fill out and return the enclosed
installation card.
A Customer Identification Number is located on the rear of the top cover. If
you are capitalizing this equipment, use this number in your records as
identification of the printer, and place your asset tag on the top cover.
Become familiar with the information in the next section before you oper-
ate the printer with your system.
Advertisement
Table of Contents
