Advertisement
Installing the Firmware
Software
Requirements
Kit Contents
Tool
Requirements
Caution
Version 2.1 of the controller firmware ROM chips must be
installed in a PrintServer 17/300 printer if you are booting from
NetWare. The minimum version of PrintServer software required
to boot from NetWare is Version 5.0.
The firmware upgrade is not required for PrintServer 17/600
printers.
The upgrade kit (order number 4A–LPS1X–FW) contains:
• ROM chips (2)
• Antistatic wrist strap
• This document
The procedure for installing the Version 2.1 controller firmware
requires the following tools:
• Flat work surface — for working on the controller board
• Flat blade screwdriver — for loosening and tightening captive
screws and for extracting ROM chips
• Antistatic wrist strap — for preventing damage to electronic
components
Your upgrade kit includes an antistatic wrist strap.
Take these precautions while performing the installation
procedure:
• Static electricity can damage electronic components on
the controller board. Use the antistatic wrist strap to
ground yourself to a metal object.
• Work on a flat surface to keep from bending the
controller board.
• Be careful not to gouge any components on the
controller board with the screwdriver.
• Be careful when handling the ROM chips. The pins
bend easily and damage is not covered by warranty.
Installing the Firmware
1
Advertisement
