Shut Down & Clean-Up; Storage - Kärcher HD 2.8/10 ST Ed B Operator's Manual

STEP 1: Remove deter-
gent suction tube from
soap container and insert
into one gallon of fresh
water. Use black soap
nozzle with detergent in-
jector. Pull trigger on spray
gun and siphon water for
one minute.
Pump
Water
Inlet
STEP 5: Disconnect the garden hose
from the water inlet on the machine.
Protect from freezing.
Pump Storage
CAUTION: Always store your pres-
sure washer in a location where the
temperature will not fall below 32° F
(0° C). The pump in this machine is
susceptible to permanent damage if
CAUTION
frozen.
FREEZE DAMAGE IS NOT COVERED BY WARRANTY.
If you must store your pressure washer in a location
where the temperature is below 32° F, you can minimize
the chance of damage to your machine by draining your
machine as follows:
1. Stop the pressure washer and detach supply hose
and high pressure hose. Squeeze the trigger of
the spray gun to drain all water from the wand and
hose.
2. Restart pressure washer and let it run briefly (about
5 seconds) until water no longer discharges from
the high pressure outlet.
10
SHUTTING DOWN AND CLEAN-UP
STEP 2: Turn off machine
by pushing switch on front
panel.
High Pressure
Outlet
STEP 6: Disconnect the high pressure
hose from high pressure outlet.

STORAGE

9.800-086.0 • Rev. 6/10
STEP 3: Turn off water
supply.
STEP 4: Press trigger to
release water pressure.
Safety
Latch
STEP 7: Engage the spray
gun safety lock.