Table of Contents
Advertisement
QUALIFIED
INSTALLER
Alternate Inlet Connection
In cases where local codes do not permit the fl ex
connector to be used inside the appliance case,
reconnect the fl ex connector outside of the appliance
case. A cut-out is provided in the appliance case for
this purpose.
1. Remove fl ex connector.
2. Remove fl ared connector.
3. Install new inlet elbow.
OR
3/8" elbow
+ short 3/8"
nipple
Common fi ttings required (not supplied)
26
Supply Gas Installation
Option 1
4. Add fl ared connector to new
elbow and fi t fl ex connector.
Close the access panel.
Flex connector redirected using one elbow.
3/8" street
elbow(s)
(where al-
lowed)
Use common elbow and fi ttings (not
supplied) to redirect the position of
the fl ex connector. NOTE: the fl ex
connector bend radius must be no
smaller than the size of a golf ball
(approx. 1-3/4" or 44 mm).
4. Add another elbow, the fl ared
Flex connector redirected using two elbows.
Top view, left side
Front view,
left side
Cut-out
Option 2
connector and refi t the fl ex
connector. Direct it towards
the rear of the appliance or
downward.
Close the access panel.
Advertisement
Table of Contents
