Valor 785ILNV2 Installation And Owner's Manual page 11

•
T E M P
Temperature Mode (Appliance
must be in standby mode; pilot
ignited) - The room temperature
is measured and compared to the
Nighttime Setback temperature.
The fl ame height is then automati-
cally adjusted to achieve the Night-
time Setback Temperature.
•
TIMER
must be in standby mode; pilot
ignited) - The timers P1 and P2
(Program 1, Program 2) each can
be programmed to go ON and OFF
at specifi c times. For instructions
see Timer Programming Mode.
NOTE: The display shows the set temperature every
30 seconds.
CIRCULATING FAN OPERATION
(if equipped)
-
Circulating Fan
speed levels from low (1 bar) to high (4 bars).
• Briefl y press SET button to scroll
to
icons fl ash.
• Press
switch ON and increase fan speed.
• Press
to decrease fan speed. To turn
OFF fan, press
button until all 4 speed level bars
disappear.
NOTE: 8 seconds after the fan has been set, the
handset will automatically go into temperature
control mode. The fan starts 4 minutes after
the gas opens (from OFF or from pilot) at
maximum speed and goes to the displayed
level after 10 seconds. The fan stops 10
minutes after the gas is OFF or at pilot.
Remote Control Operation
- Nighttime Setback
- Timer Mode (Appliance
-
The circulating fan has 4
(fan) mode. Fan and Level
(large fl ame) button to
(small fl ame) button
(small fl ame)
TO OPEN AND CLOSE DOUBLE BURNER
(785 fi replace models only)
NOTE: The rear part of the double burner cannot be ac-
tivated manually: it can only function with the re-
mote control. However, if the battery runs down,
the rear part of the burner will run according
its the last operating position. During normal
operation when lit with the remote control, both
parts of the burner turn on regardless of the set-
ting during the last use of the fi replace.
• Upon ignition both parts of the
burner are ON.
• Simultaneously press SET and
(small fl ame) buttons to switch
the rear burner OFF. Printed
instructions are on the handset's
battery cover.
• Simultaneously press SET and
Rear burner
(large fl ame) buttons to switch rear
OFF
part of the burner on. The AUX
symbol on the handset display
indicates that the rear part of the
burner is ON.
NOTE: The function AUX is
Rear burner
ON
Double burner ON/
OFF commands
diagram at the rear
of the handset
Tip
Set the different parameters when they are fl ashing.
OWNER'S
INFORMATION
blocked in programming
mode (TIMER, P1 or P2)
when the Nighttime Set-
back Temperature
is set at --
.
T E M P
11