Supports 4k uhd 60 hz 4:4:4, hdcp 2.2 and hdr de-embedded analog and digital audio outputs smart edid management can scale 4k to 1080p at each output (8 pages)
Video to pc/hdtv switching scaler with optional audio, component, s-video, composite, and pc inputs scaled vga or hdtv component output front panel, ir remote, & rs-232 serial control (20 pages)
Hdmi distribution and switching over lan with rs-232 & ir extension dynamic virtual matrix (24 pages)
Summary of Contents for Hall Research Technologies SC-HDMI-2A
Page 1
SC-HDMI-2A HDMI Scaler & Audio Extractor Scale HDMI or DVI signal and extract or embed digital or analog audio to HDMI UMA1196 Rev. A CUSTOMER Order toll-free in the U.S. 800-959-6439 FREE technical support, Call 714-641-6607 or fax 714-641-6698 SUPPORT Mail order: Hall Research, 1163 Warner Ave.
HDMI Scaler & Audio Extractor TRADEMARKS USED IN THIS MANUAL Hall Research and its logo are trademarks of Hall Research. Any other trademarks mentioned in this manual are acknowledged as the property of the trademark owners. FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance...
HDMI Scaler & Audio Extractor 1. Introduction 1.1 General The SC-HDMI-2A can scale a DVI or HDMI signal up or down to various resolutions. It can embed external analog or digital audio sources in to the output HDMI stream, and conversely can extract audio from HDMI source and output it in both analog (L/R line level) and digital (S/PDIF TOSLINK) formats.
Model SC-HDMI-2A 2. Installation Figure 1 - Inputs HDMI – HDMI input from source AUDIO – 3.5mm stereo jack input from source TOSLINK – S/PDIF Optical (TOSLINK) input from source DC 5V – 5V DC voltage, center positive Notice Use only regulated 5v DC supply as supplied with the unit.
HDMI Scaler & Audio Extractor 3. Operation 3.1 OSD Menu Pressing the Menu button will bring up the OSD menu controls on the screen. Use the up and down arrows to your desired item, then press MENU to select and enter into sub menu. Select EXIT from a submenu to go back to the main menu or from the main menu to exit the OSD.
Model SC-HDMI-2A 3.2 Obtaining an image on the screen As shipped from the factory or after a factory default reset, the unit output resolution setting should be “NATIVE”. This means that upon power-up the device will read the EDID of your display and output a compatible resolution resulting in a picture.
This is due to added latency due to processing of video that occurs in the display. The SC-HDMI-2A can correct for this with a built-in audio delay of 40ms, 110ms, or 150ms. If a different delay time is...
Model SC-HDMI-2A 4. Troubleshooting There are no field serviceable parts or circuits in the device. If you think the device is malfunctioning (or you have no picture output), please try to use the methods described in Section 3.2 to obtain a picture first. If that does not work, try resetting back to the Factory Defaults as described in 3.6.