Oce Arizona 250 GT User Manual page 54

Print Job Control Module
[19]
[34]
[34] Command Toolbar
Print job
Hold job
Cancel job
Delete job
Flatbed
Media
Thickness
Lamp Power
Control
Ink
Temperature
Control
54 Chapter 4 How to Navigate the User Interface
This command can do the following actions depending on
context:
Activates a selected inactive job by moving it to the active
list.
Un-holds a held job.
Un-holds an job that had an error currently.
The command can do following actions depending on context:
Puts an active job on hold.
Waits until the printer finishes a currently printing copy and
puts the job on hold.
The command can do following actions depending on context:
Deactivates a selected active job by moving it to the inactive
list.
Cancels a currently printing job and moves it to the inactive
list.
Deletes a job from the printer. However, cannot delete a job that
is currently printing.
Process flatbed jobs toggle command - Allows printer to process
flatbed jobs. This must be selected to enable flatbed printing
when the printer is booted or after re-setting the printer due to an
error. Note: Other job types will be added at a later date.
Enter or confirm the thickness of the media. The printer will
automatically adjust the carriage height to media thickness and
also the print gap. Media thickness confirmation is required only
for the first copy of a print job, unless it is changed during
printing. If the media thickness value is changed while printing,
confirmation is requested before printing the next copy.
Allows the operator to control the power output of each UV lamp
independently. To extend lamp life, use the lowest setting that
provides adequate curing for a particular media. Leading and
Trailing Edge are relative to the direction of carriage travel.
This button controls the ink heater and also displays the ink
temperature. The state of the button reflects the status of the ink
heater. The heater times out after two hours of inactivity (time
can be changed up to four hours by a service technician). If the
ink heater is turned off when timeout expired, then the button
changes its status to unchecked.
The print heads must be at operating temperature (47°C - 116°F)
before a job will start printing.