CN2600 Series
Configuring the Route Table
You can access the Route Table by expanding System Management and then Misc. Network Settings in
the navigation panel. The route table is where you configure how the CN2600 will connect to an outside
network.
You are allowed up to 32 entries in the route table. For each entry, you must provide information on the
gateway, destination, netmask, metric hops, and interface.
Gateway: This is the IP address of the next-hop router.
Destination: This is the host's IP address or the network address of the route's destination.
Netmask: This is the destination network's netmask.
Metric: Enter the number of hops from the source to the destinationto allow the CN2600 to prioritize the
routing of data packets if more than one router is available.
Iface: This is the network interface to which the packet must be sent.
ATTENTION
When a serial port is configured for PPP/SLIP, the Iface field must be set to that serial port for proper
communication.
Configuration with the Web Console
5-9