Load Factory Defaults; Change Password - Moxa Technologies CN2600 Series User Manual

CN2600 Series

Load Factory Defaults

This function will reset all of CN2600's settings to the factory default values. All previous settings including the
console password will be lost. If you wish to keep the CN2600 IP address, netmask, and other IP settings, make
sure Keep IP settings is checked off before loading the factory defaults.

Change Password

For all changes to the CN2600's password protection settings, you will first need to enter the old password.
Leave this blank if you are setting up password protection for the first time. To set up a new password or change
the existing password, enter your desired password under both New password and Confirm password. To
remove password protection, leave the New password and Confirm password boxes blank.
ATTENTION
If you forget the password, the ONLY way to configure the CN2600 is by using the reset button on the CN2600's
casing to load the factory defaults.
Before you set a password for the first time, it is a good idea to export the configuration to a file when you have
finished setting up your CN2600. Your configuration can then be easily imported back into the CN2600 if you
need to reset the CN2600 due to a forgotten password or for other reasons. Please refer to the section on
Configuration Import/Export earlier in this chapter for more details.
System Management Settings
8-12