Sata (Serial Ata) Disk Interface (J21 - J26) - Kontron KTD-N0850-B User Manual

KTD-N0850-B
6.5 SATA (Serial ATA) Disk interface (J21 – J26)
The KTQM77 has an integrated SATA Host controller (PCH in the QM77 chipset) that supports
independent DMA operation on six ports. One device can be installed on each port for a maximum of six
SATA devices. A point-to-point interface (SATA cable) is used for host to device connections. Data
transfer rates of up to 6.0Gb/s (typically 600MB/s) on SATA0 and SATA1 and 3.0Gb/s (typically
300MB/s) on SATA2, SATA3, SATA4 and SATA5.
Note: Before installing OS on a SATA drive make sure the drive is not a former member of a RAID
system. If so some hidden data on the disk has to be erased. To do this, connect two SATA drives and
select RAID in BIOS. Save settings and select <Ctrl> <I> while booting to enter the RAID setup menu.
Now the hidden RAID data will be erased from the selected SATA drive.
The SATA controller supports:
2 to 6-drive RAID 0 (data striping)
2-drive RAID 1 (data mirroring)
3 to 6-drive RAID 5 (block-level striping with parity).
4-drive RAID 10 (data striping and mirroring)
2 to 6-drive matrix RAID, different parts of a single drive can be assigned to different RAID devices.
AHCI (Advanced Host Controller Interface)
NCQ (Native Command Queuing). NCQ is for faster data access.
Hot Swap
Intel® Rapid Recover Technology
2 – 256TB volume (Data volumes only)
Capacity expansion
TRIM in Windows 7 (in AHCI and RAID mode for drives not part of a RAID volume). (TRIM is for
SSD data garbage handling).
The RAID (Redundant Array of Independent Drives) functionality is based on a firmware system with
support for RAID modes 0 1, 5 and 10.
SATA connector pinning:
SATA0 (J21), SATA1 (J22), SATA2 (J23), SATA3 (J24), SATA4 (J25) and SATA5 (J26).
PIN
1
2
3
4
5
6
7
Signal Description
SATA* RX+ Host transmitter differential signal pair
SATA* RX-
Host receiver differential signal pair
SATA* TX+
SATA* TX-
"*" specifies 0, 1, 2, 3, 4, 5 depending on SATA port.
Available cable kit:
Page 40
Signal Type
GND PWR
SATA* TX+
SATA* TX-
GND PWR
SATA* RX-
SATA* RX+
GND PWR
PN 821035 Cable SATA 500mm
Internal Connectors
Pull
Ioh/Iol Note
U/D
- -
- -
- -
KTQM77/mITX Users Guide