Section 14 Maintenance - Steel City 35903 User Manual

5. Using a padlock (not provided), it is possible to lock
the switch to prevent unauthorized use. Lift the red
"OFF" paddle and place a padlock through the
holes (C) in the side of the
lock the padlock. Make sure keys have been
removed from padlock and placed where no
children can get them.
6. To use the table saw, unlock and remove the
padlock from the "ON"
THERMAL-OVERLOAD
PROTECTION
WARNING
!
• Turn the power switch
cord from its power source prior to doing or perform-
ing any maintenance.
• Make certain that the
pressed before pushing the thermal-overload reset
button.
The motor supplied with your table saw has a (re-
settable) thermal-overload relay located on the side of
the switch. If the motor shuts off during an operation
(cutting a workpiece too fast or using a dull blade, using
the saw beyond its capacity, or low voltage) press the
"OFF" button and let the motor cool three to five
minutes. Push the reset thermal-overload button on the
side of the ON/OFF switch assembly. Make certain that
the saw blade and work area has been cleared of debris
before restarting saw. The motor can now be turned on
again.
WARNING
!
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
WARNING
!
ALWAYS wear eye protection. Any machine can
throw debris into the eyes during operations, which
could cause severe and permanent eye damage.
Everyday eyeglasses are
ALWAYS wear Safety Goggles (that comply with
ANSI standard Z87.1) when operating power tools.
WARNING
!
ALWAYS wear a NIOSH/OSHA approved dust mask
to prevent inhaling dangerous dust or airborne
particles.
"ON" button and then
SEE FIG 39.
button.
"OFF" and unplug the power
"OFF" button has been de-
NOT safety glasses.
WARNING
!
The following section was designed to give
instructions on the basic operations of this table
saw. However, it is in no way comprehensive of
every table saw application. It is strongly recom-
mended that you read books, trade magazines, or
get formal training to maximize the potential of
your table saw and to minimize the risks.
WARNING
!
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
PRE-RUN CHECK
Before you begin to use your Table Saw, you should
give it a thorough inspection, making sure you ask
yourself the following questions:
1. Is the blade mounted correctly?
2. Is the saw stable?
3. Is it wired properly?
4. Is the electrical system properly configured?
5. Have you checked your workpiece for obvious
defects?
6. Is the guard assembly installed and functional?
7. Have you checked the saw blade clearance when it
is adjusted to varying angles and depths?
8. Have you read all the warnings and directions
regarding the operation of this machine?
TEST RUN
1. Face the table saw and stand to the left of the blade
path.
2. With one finger on the ON button and one finger on
the OFF button, turn the saw on. Be ready to turn the
saw off in case of a mishap.
3. Watch and listen to the saw. Note whether there are
any unusual sounds or excessive vibrations.
4. If anything appears abnormal, immediately turn off
the saw, unplug it, and fix the problems. If a problem
exists that is beyond the scope of this manual,
contact your dealer.
5. If the saw is operating properly, turn it off and
prepare to make a cut according to the instructions
outlined in this section.
30