Configuring Your Ta Using A Terminal Program - ZyXEL Communications Omni TA128 User Manual

Configuring your TA using a Terminal
program
If you are not using the ISDN configuration utility that is packaged
with the TA128, you will need a terminal program with which to
configure the unit. The TA128 should work with any asynchronous
terminal program that can communicate directly with one of the
communication ports on your system. If you do not know how to use
a terminal program, refer to the instructions that came with the
terminal program.
Make sure the program is set up to communicate with the COM port
that the TA128 is connected to. You can check to see if the DTR
LED is on when the terminal program is active. In most cases, if the
terminal program is active and ready to communicate with the port
that the TA128 is connected to, it will activate the DTR signal. This
will cause the DTR LED to light up. If the DTR LED is not ON, you
will need to check the program's settings.
The communication speed can be set to anywhere between 2,400bps
and 460,800bps, but 115,200bps is a good default value. The TA128
will automatically adjust its speed to match your communication
speed.
Once the terminal communication program is ready, you can type a
simple command to see if the TA128 responds.
Type:
AT<Enter>
TA128 should respond:
OK
Type:
ATI<Enter>
TA128 should respond:
1281
14