Remote Access To Management Gui - Seneca XVAULT xNVR200 Hardware User's Manual

MONiTOr, KeYBOard & MOUse CONNeCTiONs
a single video monitor may be connected to the HDMI OR DVI connector but not both. the two denoted USB ports are used for key-
board and mouse connection. these ports are KVM compatible.
CaMera/ViewiNG/MaNaGeMeNT NeTwOrK CONNeCTiONs
the xNVRs use standard Cat 6 cabling. the xNVR's come standard with two 10/100/1000 802.11 network ports. the ports ship
from the factory with the following fixed IP addresses;
IP aDDRESS
Port 0 192.168.1.253
Port 1 192.168.1.252
NOTe: Each xNVR on the network must have a unique IP address.
isCsi/Nas NeTwOrK CONNeCTiONs
iSCSI and NaS connections use standard Cat6 cabling. the xNVR can be optionally equipped to support iSCSI/NaS external storage
appliances. iSCSI IP SaN storage requires the SaN be isolated for any other laN or WaN. as such separate 1GbE ports are supplied to
support the IP SaN. It is highly recommended to use fixed non-routable IP addresses to support the IP SaN. For customer convenience,
the ports have the following default settings.
IP aDDRESS
Port 2 10.0.10.254
Port 3 10.0.10.253
NOTe: Each IP SaN member on the storage area network must have a unique IP address.
raid exPaNsiON POrT CONNeCTiON
the xNVR can be optionally equipped with the ability to expand using direct attached storage enclosures. Up to four external drive en-
closures are supported. the interconnect cable used is an industry standard SFF-8088 to SFF-8088 cable. External chassis supplied
by Seneca come with the cable to connect to the xNVR.
C. reMOTe aCCess TO THe MaNaGeMeNT GUi
all xNVRs have the ability to be remotely accessed for management. this is accomplished by using the Remote Desktop Connection
services. any PC or Desktop running a Microsoft Operating System that is connected to the same subnet or directly connected to a
Camera/Viewing/Management Port 0 can remotely access the xNVR
Open the PC/laptop Remote Desktop Connection and enter the xNVR IP ad-
dress as shipped from the factory.
You will be prompted for the username and password of the system. Upon suc-
cessful entry the standard OS window will appear and navigation can proceed
as if using a directly attached monitor and keyboard.
xVault xNVR200/300/400 User Guide V2.0.0
MaSK GatEWaY
255.255.255.0 192.168.1.1
255.255.255.0 192.168.1.1
MaSK GatEWaY
255.255.255.0 blank
255.255.255.0 blank
15