Cabling & Connections - Seneca XVAULT xNVR200 Hardware User's Manual

ii. reMOViNG driVe TraY
Press "lever Release Button". the tray "Extraction/Insertion lever" will pop out on the right side. Gently rotate the lever out-
ward and at the same time cradle the drive tray underneath with your free hand. When the drive lever is fully extended, slide the
drive tray out of the enclosure.
iii. iNserTiNG driVe TraY
Match tray number to enclosure slot number. With the lever fully extended, slowly slide the tray into the slot until lever engages en-
closure. Gently push drive lever in, the tray should slide into the enclosure without significant force on the lever or tray. Push lever
in until the lever release button locks, there should be a distinct "click" when this happens. If the lever does not move in at corre-
sponding rate as the tray slides into the enclosure, StOP! Pull the tray back out and try again. When the tray is correctly installed it
should be flush with all other trays in the enclosure.
NEVER move the tray in fast or force the lever to close. Damage will occur to the tray and possibly to the drive connector.
B. CaBLiNG & CONNeCTiON
XNVR video recorder appliances come in three form factors but all use common components and cabling points. there are only six
main cabling groups;
• Power
• Monitor/Keyboard/Mouse
• Camera/Viewing/Management Network
• iSCSI/NaS Network (option)
• RaID Expansion Port (option on some models)
POwer COrds
all xVault storage appliances come with redundant hot swap power supplies. Each power supply requires its own power cord. the
power cords supplied are standard 115VaC machine cords. Care should be taken to always route aC power cords away from cables
that transmit data.
It is also recommended that each power cord have a separate electrical path back to the facility service entrance. Meaning each
power cord should be connected to separate circuit breakers. It is also prudent to have at least one of the power cords connected to
an uninterruptable power source.
xVault xNVR200/300/400 User Guide V2.0.0
Lever release Button
extraction/insertion Lever
13