3. Restore the main burners. CAUTION: Make sure the value with orifice is inserted into the burner venturi.
Restore the igniter brackets; adjust the distance between the burner and the corresponding igniter for proper
ignition.
Searing Side Burner Conversion
Tools required:
Phillips Head Screwdriver (+)
6mm Nut Driver
1. Loosen the igniter wire screws, searing side burner brace screws, and two screws securing searing side
burners.
2. Take out the searing side burner from the firebox. Locate orifice on end of valve and remove by turning
counterclockwise with a 6mm nut driver .
3. Insert NG orifice with a 6mm nut driver, then secure turning clockwise. Replace the searing side burner and
igniter wire back.
19