Advertisement
2) Check the location of leading edge of media in the printer.
If the leading edge passes over the Gate Roller (C)
As shown in the diagram, you will need to cut the
roll media.
Following steps 3) and 4) if this occurs.
If the leading edge does not reach the Gate
Roller (C), you do not have to cut
the roll media.
Skip steps 3) and 4), and go to the
step 5).
3) There is a Cutter Switch (D) on the front side of
printer.
The knife will cut the roll media if you press it.
Please, press the Cutter Switch.
NOTE
(1) You do not have to close the Upper Unit before pressing the Cutter Switch.
(2) Once you move the Knife, it will not move again, even if you press the Cutter Switch
again.
(3) Do not press the Cutter Switch if the leading edge of roll media does not reach
the Gate Roller.
If you cut the roll media ignoring this note, it may be impossible for the user to
remove the mis-feed media from the printer.
K66um3e2eng.doc (Ver. A.2)
C
C
3-7
D
Advertisement
