KIP 2001 User Manual page 29

5) Loosen the Thumb Screw (D), and slide the Stopper (E) according to the width of the new roll
of media.
Tighten the Thumb Screw to fix the Stopper at the corresponding size mark.
NOTE
Place the Stopper so that the flat face (F) and the
size mark (G) are aligned with each other.
6) Insert the Roll Spool into the new roll inserting the
gear side into the roll first as shown ( note the
direction on how the media is wound onto the core ).
NOTE
Do not install the roll as shown here.
K66um2e2eng.doc (Ver. A.2)
E
D
Good
G
2-11
No good
F
No good
No good