Tv Signal Amplifier; Cable Tv And Satellite Dish Connections; Tv Digital Satellite System Wiring - Winnebago 2014 Sightseer Operator's Manual

6. Rotate antenna to illuminate the last flickering
LED light.
7. Repeat Steps 5 and 6 to pinpoint signal
reception.
NOTE: Refer to television manufacturer's
instructions to scan for available
channels.
Further Information
See the antenna manufacturer's user guide
provided in your InfoCase for complete operating
and maintenance information.

TV SIGNAL AMPLIFIER

The TV Signal Amplifier is built into the
antenna and can be turned on or off with a power
switch located on a switchplate near the
entertainment center cabinet.
An indicator light will illuminate when the
switch is on and the signal amplifier is active.
TV Signal Amplifier Power Switch
(Located in an overhead cabinet or mounted
on a wall near the TV)
-Typical View
CABLE TV AND SATELLITE
DISH CONNECTIONS
The cable TV and satellite dish connections
are located in the water service center.
TV DIGITAL SATELLITE
SYSTEM WIRING
digital satellite TV system. Coaxial cable and
high definition component cable connections are
available to hook up your satellite receiver and
are located in a cabinet near the TV.
• Power
Switch
cabinet in the bedroom for the rear TV (if
equipped).
dealer for proper installation and sealing of roof
mounted components.
ENTERTAINMENT
Exterior Connections for
Cable TV and Satellite Dish
(Located in water service center)
-Typical View
Your coach is pre-wired for installation of a
A second connection may be included inside a
See your authorized Winnebago Industries
Interior Connection for Satellite Dish
(Located in a cabinet near TV)
-Typical View
SECTION 8 –
®
8-7