Slideout Emergency Retraction (Lippert) - Winnebago 2014 Sightseer Operator's Manual

4. Crank the room(s) until it is just "snugged up."
Do not over-crank or you could damage the
gear assembly.
5. While maintaining pressure on ratchet
wrenches, re-engage the motor brake by
moving lever clockwise slightly - or to right
when facing end of motor (repeat for motor at
other end of room, if equipped).
6. Reconnect motor power lead to wiring
harness (repeat for motor at other end of room,
if equipped).
7. Fasten slideout room travel latching device (if
equipped) inside the coach before driving the
vehicle.
8. See your dealer for service of the slideout
mechanism before using again.
Further Information
See the Slideout Room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
SLIDEOUT EMERGENCY
RETRACTION (LIPPERT)
–If Equipped
If the slideout mechanism is malfunctioning
and the room will not retract using the interior
control switch or exterior control panel, you may
need to access the slideout motors and manually
push the room in to the travel position.
There are two slideout motors equipped on the
end wall of each slideout room. Pull back wipe
seal to access motors.
NOTE: Use caution when removing components
on painted units.
Push-In Procedure
1. Using a razor blade, remove sealant from the
top of screw cover.
SLIDEOUT ROOMS AND LEVELING
2. Using a flat-head screwdriver, push it up
underneath the screw cover and pull up to
release the cover. Remove the rest of the cover
by hand and set aside.
3. Remove the top (4) pan head screws and top
(4) flat head screws at the top of the aluminum
trim.
4. Gently pull aluminum trim away from
sidewall with hand to disengage screw from
motor.
SECTION 10 –
10-9