Operating Instructions; Connecting Lp Gas Cylinder To Grill; Sear Burner Operation - Smoke hollow Deluxe Outdoor Grill & Smoker 8500 Assembly And Operation Instructions Manual

OPERATING INSTRUCTIONS

Connecting the LP gas cylinder to the grill
The LP Gas Cylinder must be a 20 pound cylinder and have a Type 1 Cylinder Valve Outlet
●
Connector.
Handle the Cylinder with care - do not drop it.
●
When you are not using the grill, the LP Gas Cylinder should be dis-
●
connected.
Connect the regulator and hand tighten firmly.
●
Do a leak test each time you connect a LP Gas Cylinder and before
●
lighting the grill.
Never use a match or lit flame to test for leaks.
●
To test, prepare a weak solution of detergent and water. Spray or
●
swab the solution onto the connection of the regulator to the LP Gas
Cylinder valve, and on all the joints in the hose connections up to the burner valves (which
MUST be closed in the "OFF" position).
Open the LP Gas Cylinder valve, and watch for any bubbles to appear at all the connection
●
points. No bubbles indicate - All Clear!
If there are any bubbles, there is a leak which must be fixed.
●
Never obstruct the flow of combustion and ventilation air.
●
Lighting the grill
Always open the Lid before lighting the grill.
●
All burner knobs should be in the "OFF" position.
●
Open the LP Gas Cylinder valve,1-1 1/2 turns.
●
Note: EACH of the 3 main burners on your grill has its own automatic igniter.
●
Push the knob in fully, and slowly turn it counter-clockwise (to the left) to the "HIGH" position.
●
You will hear a loud "Click" as the igniter sparks and lights the burner
You can then adjust the knob to your desired setting.
●
If the burner did not light, turn the knob back to the "OFF" position, wait 5 minutes for any gas
●
to clear away, and then repeat the lighting procedure.
For Sear Burner, turn the knob counter-clockwise (to the left) and then PUSH the Black Ig-
●
niter Button several times to light the burner. If the burner does not light ,then turn the knob to
the "OFF" position, wait 5 minutes and then try again.
After using the grill, - turn all burner knobs to the
●
"HIGH" position and then push fully in and turn to the
"OFF" position.
At once turn the valve on the LP Gas Cylinder OFF.
●
IF the auto-igniter does NOT light the burner, you can light
●
it with a match or a piece of burning paper - hold the
match or paper with the Match Holder ( attached at the
side of the grill) , put it through the openings in the Cooking
Grid and next to the Flame Tent covering the burner. Then follow the
lighting procedure above.
Observe the proper burner flame - it should be a blue/yellow color about 1/2" long.
●

Sear Burner Operation

ALWAYS be sure to OPEN the Lid before lighting the Sear Burner and leave open during
●
use. Leave Sear Burner open until it is completely cool.
Preheat the Burner for 5 minutes
●
Sear one side of the food, turn the food over and sear the other side. Then continue cooking
●
each side of the food on the standard burners until done to your satisfaction.
Good Flame
19
OFF
OFF
"click"
Bad Flame
YELLOW
BLUE
Burner