Smoke hollow Deluxe Outdoor Grill & Smoker 8500 Assembly And Operation Instructions Manual page 13

Assembly
Step 13
Fig.13
Step 14
Inside Cabinet
Firebox Door Handle
Fig.14A
Hole
Fig.14 B
Fig.14C
Fig.14D
13
Step 13: Attach the Firebox Door Handle
Locate: Firebox and Lid Assembly, Firebox Door
Handle, (1) M6x15 bolt and (1) Metal lock nut
Procedure: Refer to Fig. 13 and Place the Fire-
box Door Handle on the outside of the Firebox
Door and insert an M6x15 bolt through the Door
Handle and the Door as shown. Attach an M6
metal lock nut. Tighten with wrench or pliers until
the Handle can still move freely.
Step 14: Installing the Charcoal Tray Lifting
System
Locate: Charcoal Tray Lift Handle, Charcoal
Tray Lifting System, (4) M6x15 bolts, (2) Hinge
Pins and (2) "R" Clips
Procedure:
Slide the charcoal tray lift handle through the
adjusting slot and through the hole of the inside
plate as shown in Figure 14A. Align the hole in
the end of the lift handle with the holes in the "U"
shaped bracket located at the back of the cabi-
net. Join the lift handle and the "U" shaped
bracket by inserting a hinge pin as shown in Fig-
ure 14B. Then insert an "R" clip though the hole
in the hinge pin.
Place the charcoal tray lifting system into the
cabinet and attach it to the back wall by inserting
(4) M6x15 bolts through the back side of the
cabinet wall as shown in Figure 14C.
Attach the charcoal tray lift handle to the char-
coal tray lifting system by inserting a hinge pin
through the "U" shaped lifting arm and the hole
in the center of the lifting handle as shown in
Figure 14D. Then insert an "R" clip through the
hole in the hinge pin.
You should now be able to adjust the charcoal
tray lifting system to your desired height by mov-
ing the lifting handle to the left and raising or
lowering it.