Gabarron ADL 5030 Installation Instructions And User Manual page 5

Dynamic Storage Heaters
8.- Check that the heating element rests completely on the bricks without restricting a new row (Fig. 4).
fig. 4
9.- Arrange two new rows of bricks, ensuring the flat side of each bricks is facing towards the bottom of the heater, and
insert a new heating element. Repeat the operation for the third heating element. Place the last row of bricks also with
the flat side toward the bottom of the heater. Check there is no gap between bricks.
10.- Connect the heater following the enclosed diagram. Ensure all connections are correct and that no connection is
damaged. Do not leave any remaining wire inside the heater.
11.- Refit the inner front panel. If the bricks have been fitted correctly you will find no difficulty during this action.
fig. 5
12.- Attach the front panel by hanging it on the "V" in the upper part and securing it at the bottom with the two screws.
13.- Finally, fit the outlet grill with the four screws.
5