Dynamic Storage Heaters
5.- Attach the LH & RH spacers to the storage heater using the screws
supplied, in the same way as the screws are fixed in the upper rear section of
the heater side. Check the heater is separated 25mm from the wall at the top
and bottom of the heater (Fig. 2). Fit and screw the appliance to the anti-tilt
device.
fig. 2
6.- Remove the inner front panel.
WARNING!
At the other side of this part there is a breakable panel of thermal
isolation. It must be handle with care. Avoid touching it.
7.- Place a row of storage bricks carefully, with the flat side heading the bottom of the heater. Insert one of the heating
elements in the holes in the right side insulation (Fig. 3).
4