Motorola Timeport 280 Service Manual page 38

Disassembly
G
G
34
2. Disengage the lens catches by pushing toward the bottom of the housing as
shown in Figure 23A.
The lens is fastened to the front housing with adhesive. Exercise care when removing
to prevent damage to the front housing.
3. While holding the catches in the disengaged position, use the flat end of the
disassembly tool to pry the lens from the front housing as shown in Figure 23B.
4. Rotate the lens upward and lift from the housing.
Do not remove the transparent protective film from the front of the new lens. This
film prevents damage to the lens during service and handling. It is to be removed
only by the end user.
5. To replace, remove the protective backing from the adhesive on back of the new
lens. Be careful not to touch the adhesive.
6. Insert the lens' 2 bottom catches into the mating slots in the front housing.
7. Carefully align the lens with the front housing and rotate the lens downward
to engage the lens top catches.
8. Apply even pressure across the adhesive area of the lens to bond it to the
housing. Ensure the lens is straight and flush with the front housing.
9. Replace the speaker, IR port lens, voice button, power button, volume buttons,
microphone, keypad, transceiver board, rear housing, rear escutcheon, anten-
na, battery, and battery cover as described in the procedures.
May 14, 2001
P280
6881038B15