Motorola Timeport 280 Service Manual page 25

Level III Service Manual
G
6881038B15
3. To replace the RF grommet, press it firmly into place in the rear housing until
completely seated.
4. To remove the alert transducer, use the flat end of the disassembly tool to
carefully pry the transducer from its cavity in the rear housing. See
Figure 10B.
The alert transducer is fastened to the rear housing with adhesive. Exercise care
when removing to prevent damage to the rear housing.
5. To replace the alert transducer, remove the protective backing from the new
transducer, then press the transducer into place in the rear housing cavity. Be
sure the transducer is straight and fully seated in the cavity.
6. Replace the rear housing, rear escutcheon, antenna, SIM card, battery, and
battery cover as described in the procedures.
May 14, 2001
Disassembly
21