Setting The Display Of Native Scan Mode - Sony bvm-l230 Operation Manual

Setting the Display of
Native Scan Mode
About the native scan mode
You can set the picture display type for the native scan
mode according to the input signal.
You can select ×1 or ×2, which differ in picture display
size, to map the pixels of the signal to the panel in one-to-
one mode, or Aspect Correction. An SD signal of non-
square pixels (the number of H pixels of the signal system
is 720 or 1440) or a 640 × 480 SD signal of DVI video is
displayed correctly by scaling processing of doubling for
the V direction and correct aspect ratio for the H direction,
and the picture is also optimized and displayed by
modifying the aperture coefficient value, filter coefficient
value, etc. in Aspect Correction mode.
For details, see "Picture Display Size" on page 107.
Set the native scan mode in the Native Scan Mode menu
(page 58) of the Display Setting menu.
Display of the input signal system 2048 ×
1080
When the input signal system is 2048 × 1080 and the native
scan mode is selected, you can display no display area of
the left and right sides over the H size (1920) by sliding the
picture with the PHASE knob. You can restore the display
position to the center by pressing the MANUAL button of
PHASE of the controller.
Displayed by sliding the
picture with the PHASE knob
of the controller.
Notes
• The native scan is not selectable in the following cases:
– When the input signal has no sync signal
– When Side by Side is set to On
– When Pixel Zoom is set to on
– When Format of the Input Configuration menu is set
to DVI Computer (The native scan is displayed
regardless of the setting.)
– When a digital cinema signal (2048 × 1080) is input
and the internal signal is displayed (Native Scan is set
to Off and the normal scan is displayed regardless of
the setting.)
– When the signal system is the SD signal of 720 × 576
or 1440 × 576, Native Scan Mode is set to Aspect
Correction and the internal signal of the aspect ratio
16:9 is displayed (Native Scan is set to Off and the
normal scan is displayed regardless of the setting.)
• The set position of 2048 × 1080 is held even when the
system is changed to another input signal system.

Setting the Display of Native Scan Mode

85