Blade Assembly; Light Kit Assembly. Pgs - Litex E-GD52ABZ5C Installation Manual

9. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with Phillips screwdriver.
Repeat procedure for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat
procedure with remaining blade arms. Securely
tighten all screws.
Note: Tighten blade arm screws twice a year.
10. Light Kit Assembly (Optional).
Remove 3 screws from switch housing cap.
If you wish to use your fan WITHOUT the light
kit, align holes in switch housing cap with holes in
switch housing. (Note: Gap on edge of switch
housing cap must align with reverse switch in
switch housing for the proper fit.) Secure switch
housing cap with 3 screws that were previously
removed. Please proceed to Section 11 on the
following page to complete installation without
light kit.
If you wish to use your fan WITH the light kit,
locate BLACK (or BLUE) and WHITE wires in
switch housing labeled FOR LIGHT. Remove and
discard plastic that holds these 2 wires together.
Remove hex nut and lock washer from threaded
rod on light kit fitter. Punch center cap out of
switch housing cap with a screwdriver. Feed
wires from light kit fitter through center hole in
switch housing cap, and then screw switch
housing cap onto threaded rod followed by the
lock washer and hex nut. Tighten hex nut over
lock washer for a secure fit.
["Light Kit Assembly" continued on next
page.]
plastic
motor
lock
blade arm
lock washers
screws
switch housing
cap
switch housing cap
hex nut
lock washer
page 7
motor housing
blade
blade arm
motor housing
switch
housing
center cap
switch housing cap
light kit fitter