Martin Easypix User Manual page 4

• Disconnect the luminaire from AC power before removing or installing
any cover or part and when not in use.
• The system does not support hot swap. Turn off AC power before
adding any luminaire to the system.
• Connect the Easypix Power electrically to ground (earth).
• Use only a source of AC power that complies with local building and
electrical codes and has both overload and ground-fault (earth-fault)
protection.
• Connect a maximum of 24 Easypix 300 luminaires or 6 Easypix 1200
luminaires or any mixture of Easypix 300 and 1200 luminaires that is
maximum 7.2 m long to one Easypix Power device.
• Before using the devices, check that all power distribution equipment
and cables are in perfect condition and are rated for the current
requirements of all connected devices.
• Isolate all devices from power immediately if any cable, seal, cover or
other component is damaged, cracked or deformed. Do not reapply
power until repairs have been completed.
• The Easypix is for indoor use only.
• Refer any service operation not described in this manual to an
authorized Martin Service partner.
PROTECTION FROM BURNS
• Do not operate the devices if the ambient temperature (Ta) exceeds
40° C (104° F).
• The exterior of the luminaires and Easypix Power becomes hot, up to
65° C (149° F) during normal operation. Ensure that accidental
physical contact with the devices is impossible.
• Allow the luminaire to cool for 5 minutes before servicing.
• Keep combustible materials (for example fabric, wood, paper) at least
20 cm (8 in.) away from the devices.
• Keep flammable materials well away from the devices.
• Do not modify the Easypix Power or luminaires in any way not
described in this manual or install other than genuine Martin parts.
• Use only Martin approved accessories to mask or modify the light
beam.
• Do not attempt to bypass fuses. Replace defective fuses with ones of
the specified type and rating only.
• Install the devices indoors in a well-ventilated area only. Provide a
minimum clearance of 5 cm (2 in.) and ensure unrestricted airflow
around the Easypix Power and the luminaires.