Martin Easypix User Manual page 27

Setting up DMX-controlled operation
The Easypix Power can be controlled by sending instructions from a
DMX controller to the 3 DMX channels (out of the 512 channels
available in one DMX universe) the Easypix Power uses.
The first of these 3 channels is the Easypix Power's DMX address. You
must set the Easypix Power's DMX address as a binary number on the
unit's DIP switch with the lowest value on pin 1 and the highest value
on pin 9 (i.e. pin 1 sets 1, pin 2 sets 2, pin 3 sets 4, pin 4 sets 8, pin 5
sets 16, pin 6 sets 32, etc. in the binary number) and the controller
must send instructions to that address and the next two channels.
To save time calculating binary numbers, use Table 3. To use this table,
first find the DMX address in the main block in the table. Then read the
settings for pins 1 - 5 to the left and read the settings for pins 6 - 9
above the address. "0" means "OFF" and "1" means "ON".
For example, to set the DMX address to 101, you need to set DIP
switch pins 1, 3, 6 and 7 to ON, as highlighted in the table.
27