Table of Contents
Advertisement
Problem
The wrong
date and/or
time is
shown.
The camera
does not
respond
when I press
a button.
Chapter 7: Troubleshooting and support
Possible cause
The batteries
died or were
removed from
the camera for
too long.
The camera is
turned off or
has shut down.
The camera is
connected to a
computer.
The batteries
are drained.
Images in the
memory card
may be
corrupted.
The camera
has stopped
operating.
Solution
The date and time will be
maintained for about 10 minutes
without batteries installed. Reset
the date and time by using the
Date & Time
option in the
menu. (See page 68, 68)
Turn on the camera, or turn it off
and then on again.
Most of the camera buttons,
except for the
do not respond when the camera
is connected to a computer. If they
respond, it is only to turn the
Image Display on if it is off, or, in
some cases, turn the Image
Display off if it is on.
Replace or recharge the batteries.
Remove the memory card.
Reset the camera by holding the
switch
position until the Image Display
turns on.
Setup
switch
,
in the
ON
77
Advertisement
Table of Contents
