Log Placement; Surround Installation - Vermont Castings 30ILDVNV Installation And Operating Instructions Manual

INSERT INSTALLATION

LOG PLACEMENT

Before you begin - This unit is supplied with six (6) ceramic
fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic
fibers. After handling the logs, wash your hands gently with
soap and water to remove any traces of fibers.
INSTALLING LOGS AND ROCK WOOL (EMBER
MATERIAL) IN FIREBOX
1. Break up rock wool (ember material) into dime-sized
pieces. Place evenly as shown. Do not exceed 1" layer
covering all round burner ports. Refer to Figures 17a
and 17b.
2. Do not cover rectangular slots located at rear of burner.
Figure 17a -
Ember Material Area
Figure 17b -
Place Ember Material
20306755
The positioning of the logs is critical to the safe and
clean operation of this heater. Sooting and other
problems may result if the logs are not properly and
firmly positioned in the appliance. Never add additional
logs or embellishments such as pine cones or vermiculite
to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams
below or to use only parts specifically approved for this
heater may result in property damage or personal injury.
Do not use the entire bag of rock wool to cover burner
area.
Ember Material Area
FP1968
ember material area
9/08
Ember Material
LG536
ILDV
30ILDV Series Gas Fireplace Insert
WARNING
WARNING
19