Blower Replacement - Vermont Castings 30ILDVNV Installation And Operating Instructions Manual

FINAL INSTALLATION

BLOWER REPLACEMENT

Turn off the unit and allow to cool completely. Turn off gas
at shut-off and disconnect all electricity to unit.
1. Remove the decorative filigree by gently pulling it out.
2. Rotate the cam on the glass toward the center.
3. Tilt the glass out, lift and release it from the track.
4. Set the glass on a towel out of the way.
5. Remove the logs and bricks. To remove the brick,
unfasten the brackets located on the right and left.
6. Unfasten the brick support plate fastened to the
burner.
7. Unfasten the rectangular plate located at the rear of the
firebox by only removing the six (6) screws around the
perimeter of the plate.
8. Lift the plate up and slide to the left. You may have to
rotate the plate to clear the blower through the hole.
9. Disconnect the two (2) wires to free the blower.
10.Reassemble the blower in reverse order.
Brick Retainers
Brick Panels
Figure 30 -
Blower Removal and Assembly
20306755
Glass Door Assembly
FP1963
blower assey replace
9/08
30ILDV Series Gas Fireplace Insert
Blower Assembly
FP1963
27