Sennheiser Tourguide System 2020 Instructions For Use Manual page 36

36
Displaying the transmission frequency
To display the transmission frequency assigned to the
current channel:
Press the SET
The operating menu appears and the first menu
"CHAN" flashes on the display.
Repeatedly press the
"FREQ" flashes on the display.
Press the SET
The transmission frequency assigned to the current
channel appears on the display. You cannot change
this transmission frequency.
Press the ON/OFF
return to the operating menu.
Loading the factory-preset default settings
To load the transmitter's factory-preset default
settings:
Press the SET
The operating menu appears and the first menu
"CHAN" flashes on the display.
Repeatedly press the
"RESET" flashes on the display.
Press the SET
"RST.OK" flashes on the display.
Press the SET
default settings.
"DONE" briefly appears on the display. The
transmitter is reset to the following factory-preset
default settings:
Channel: 1
Line input: switched off
Input sensitivity
- Line input:
- Microphone input:
Lock mode: deactivated
Infra-red service interface: deactivated
button µ.
/ rocker button
button µ.
²
button or the
button µ.
/ rocker button
button µ.
µ
button to load the factory-preset
24 dB
–
36 dB
–
¾
until
µ
SET button to
¾
until