Sennheiser Tourguide System 2020 Instructions For Use Manual page 32

´ µ ¾
32
Setting the receiver channel(s) using the channel
copy function
The channel copy function lets you simultaneously set
a maximum of 19 receivers in the charging case to the
same channel. This is achieved by copying the current
channel of the receiver placed into the charging
compartment with channel copy function (master)
to all other receivers in the charging case.
Place all receivers which are to be set to the same
channel into the charging compartments for
receivers (slaves) ´.
Switch on the receiver whose channel you want to
copy.
Place this receiver into the charging compartment
with channel copy function (master) µ. The
receiver must be switched on.
The LED
as the channel copy function is available.
Press the
function.
The LC displays of all receivers which are
successfully set to the same channel light up.
Notes:
If the receivers' built-in rechargeable batteries are
º
not discharged, you can use the channel copy
function even when the charging case is not
connected to the mains.
If you do not press the
receiver placed into the charging compartment
with channel copy function (master) µ, the
receiver automatically switches off after approx.
two minutes.
COPY AVAILABLE º
¾
COPY button
lights up green as long
to start the channel copy
¾
COPY button
µ
on the