Winnebago Navion iQ Owner's Manual page 26

SECTION 2 –
SAFETY AND PRECAUTIONS
Removing the Wheel
Note: Reference the chassis manufacturer's user
guide provided in your InfoCase for
complete instructions and cautions on
changing a wheel.
1. Once the vehicle is prepared for wheel
removal, obtain the adapter from the co-driver
foot well compartment and engage the adapter
to the lug nut. The visible hex on the adapter
is the correct size for the lug wrench.
2. Slide the lug wrench onto the adapter and
rotate counter-clockwise to loosen the lug
nuts.
Note: Do not place the wheel nuts in sand or
dirt. The threads of the wheel bolts and
wheel nuts could be otherwise damaged
when being installed.
If a stylized wheel needs to be replaced with
the spare steel wheel DO NOT use the stylized
chrome wheel bright lug nuts as they do not seat
properly on the steel wheel. Use the six chassis
supplied lug nuts with attached washer located in
the co-driver foot well compartment. The chassis
supplied lug nut hex is the correct size for the lug
wrench (Do not use Adapter).
2-14
Six Chassis Supplied Lug Nuts with attached
washers (located in the co-driver foot well
compartment)
Chassis Supplied Steel Wheel/Spare
Reinstalling Stylized Chrome Wheel
Note: Reference the chassis manufacturer's user
guide provided in your InfoCase for
complete instructions and cautions on
changing a wheel.
• Once the vehicle is prepared for stylized
wheel installation, use the chrome washer,
chrome lug nut, and chrome adapter with lug
wrench to re-install the stylized chrome
wheel.