Installing A Hot-Swap Power Supply - IBM x3850 X5 7145 Installation And User Manual

10. Push down on the blue adapter retention latch until it clicks into place,
11. Connect any required cables to the adapter.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 59.

Installing a hot-swap power supply

Statement 5:
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
Power-supply
handle release
latch
36
IBM System x3850 X5 and x3950 X5 Types 7145 and 7146: Installation and User's Guide
8. Carefully grasp the adapter by its top edge or upper corners, and align it with
the connector on the I/O board.
9. Press the adapter firmly into the adapter connector.
securing the adapter.
Power-supply
handle
Power-supply
filler
Power supply
Release
latch