Installing a QPI wrap card
Release
latch
If your server has more than two microprocessors installed, you must install two
QPI wrap cards in the server.
To install a QPI wrap card, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Rotate the blue release latch on the QPI wrap card handle and pull the handle
4. Push the wrap card into the bay, and slide the handle to the locked position.
5. Reconnect the cables and power cords (see "Connecting the cables" on page
6. Turn on all attached devices and the server.
Wrap card
on page 25.
all external cables.
to the open position.
59).
Chapter 2. Installing optional devices
43