Evc Control Panel - Volvo Penta D4 Operator's Manual

Instruments

EVC control panel

The control panel is used in combination with the EVC system tachometer. The tachometer display shows oper-
ating information and menus that can be navigated from the control panel.
Activation button
Used to activate and lock the control panel and the
helm station.
Indication (red):
Off: Control panel not activated.
Lit: Control panel activated.
Flashes: Control panel not activated due to the con-
trol lever not being in neutral or the system has been
locked from another control panel.
Padlock
The padlock symbol lights if the control panel is locked
manually by depressing the
has been activated by routine "Change of control
panel during journey".
Lit: The system is locked and the engine can only be
controlled from the activated control panel.
Neutral button
Used to disengage the drive/reverse gear so that the
engine speed can be increased without driving (warm-
ing up mode).
Indication (green):
Off: Drive/reverse gear engaged.
Lit: Control lever in neutral.
Flashes: Drive/reverse gear disengaged or system in
calibration mode.
This button is also used for:
- Activation of the Volvo Penta Lowspeed/Trolling func-
tion (optional). For more information please refer to
chapter "Operation" section "Volvo Penta Lowspeed/
Trolling".
- Enabeling of emergency trimming. For more informa-
tion please refer to chapter "In case of emergency:
Emergency trimming".
26
-button, or if exchange
Navigation wheel
Used to navigate through the menus shown on the
tachometer EVC system display. Navigate through
the menus by turning the wheel. Depress the wheel to
confirm a selection.
Tachometer display selection (twin installa-
tion, port or starboard tachometer)
Is used to select which of the engines menu systems
should be navigable from the control panel. The menu
is shown on the display of the corresponding engines
tachometer. Select port or starboard.
Indication (red/green):
Off: Not possible to navigate in menu.
Lit: Possible to navigate in menu for selected engine,
port (red), starboard (green).
Multifunction button
Used to increase or decrease the instrument's and
panel's backlighting.
Depress the button for at least 1 second to turn the
backlighting on or off. The backlighting can be adjust-
ed in five stages by pressing the multifunction button.
If the button is pressed on a inactive control panel, op-
erating information is shown on the display(s) and it is
possible to navigate in the menus.
Back button
Used to back a step in the menu.
IMPORTANT! Always press the buttons firmly,
and for at least one second each time.