Volvo Penta D4 Operator's Manual page 45

Example of display in several windows for
single engine installation
Example of display in several windows for
twin engine installation
Figure for single engine
installation
Press button 5 to choose setting mode
Figure for single engine
installation
Buttons 1 to 4 are used to adjust the corresponding window
(please refer to the black markings)
Figure for twin engine
installation
Figure for twin engine
installation
Display mode Multi (button 2)
This display mode shows operating information in four
different windows (see below). The user can choose
the operating information to be displayed in each win-
dow.
The information can be displayed as figures or as
standard instruments. Display indication shifts bet-
ween the two modes when you press button 2 repea-
tedly.
If an item of operating information is not available, the
unit displays "—" and the analogue gauge needle is
not shown.
From this display mode MULTI , you can also reach
display mode that functions in the same way as the
smaller display in the tachometer. Read more about
this display mode SYSTEM INFORMATION in the
configuration menu section.
Set the appearance of the display mode Multi
Display mode MULTI has a mode to set the operating
information to be displayed in each window.
The setting mode is reached by pressing button 5 (fur-
thest right), when you are in the display mode MULTI.
Please refer to the illustrations below.
Note! The type of operating information available
depends on the electrical system in the boat and the
sensors that the boat is equipped with. Optional sen-
sors include depth gauge, water temperature, speed,
trim angle and rudder angle.
Note! This applies to the graphic display:
The maximum engine speed range can be set on the
configuration menu.
The voltage interval can be [8V: 16V] or [16V: 32V]
and is changed automatically, depending on the latest
data value.
Instruments
43