Volvo Penta D4 Operator's Manual page 42

Instruments
SYSTEM INFORMATION display mode for sin-
gle engine installations
SYSTEM INFORMATION display mode for
twin engine installations
Control panel
Alarm example
40
Display mode System Information
SYSTEM INFORMATION is a display mode that func-
tions in the same way as the display in the tachometer
(EVC System Tachometer). You navigate round these
functions, using the buttons on the free-standing con-
trol panel.
In display mode SYSTEM INFORMATION there are
several functions:
- Display of operating information, information mes-
sages and alarm (note! The display is adapted to
suit the size of the panel in the tachometer).
- Settings for displaying operating information in this
display mode.
- All calibrations.
Detailed instructions for the functions in display mode
SYSTEM INFORMATION are found in the section
about the tachometer in this owner's manual .
Information message and alarm
The display automatically switches to display mode
SYSTEM INFORMATION when the electrical sys-
tem needs to show information messages or alarms.
Instructions about how information messages and
alarms should be handled are found in the section
about the tachometer and in the section "In case of
emergency" in this owner's manual.
Settings
Menu SETTINGS is used to do various settings for
the display.
- Language: This is where you select the langu-
age that the display should use (8 different
languages are available).
- Bleep: This is where you select whether a beep
should be heard when any button is depressed.
ON/OFF.
- Engine: This is where you select the engine for
which operating data will be displayed. SINGLE,
PORT, STARBOARD or TWIN.
- Engine series: This is where you select the
engine for which the display has been installed
D1/D2, >D2. The display is pre-set for use with
engines larger than D2.